![]() Standby Mode will now be active, after 19 minutes with no signal present the 104 Reference Monitors will enter Standby Mode. Increase the setting of the VOLUME control (rotate clockwise).Ħ. The POWER LED will flash slowly 2 times to indicate the process is complete.ĥ. Disconnect headphones to the HEADPHONE output on the MASTER MONITOR.ĭ) Disconnect the headphones NOTE: This procedure must be completed within 15 seconds after performing Step 4. ![]() To re-enable Standby Mode, use the following procedure:Ģ. The POWER LED will flash rapidly 5 times to indicate the process is complete. NOTE: This procedure must be completed within 15 seconds after performing Step 4. Within a period of 15 seconds Complete the following steps:ĭ) Reconnect headphones again. Set the VOLUME control to the minimum (full counter-clockwise) setting.Ĥ. Connect headphones to the HEADPHONE output on the MASTER MONITOR.ģ. Sleep Mode Disable & Re-Enable: To Disable Standby Mode, use the following procedure:Ģ. On your phone, laptop or tablet select the 104SET-BT from BT menu, once connected the Led will stop flashing Ĥ. To Pair a Bluetooth device, hold down input selector button to change to Bluetooth and push, input select button until LED begin flashing, You can monitor all inputs sources simultaneously. Such as audio interfaces and monitor stations, to the ¼” (TRS) inputs.ĭ) RCA Left and Right Inputs can be used to connect consumer equipment with low level (-10dbv) outputs, such as CD player or turntables.Į) The INPUT SELECTOR button can be used to switch between Bluetooth, Aux, RCA, TRS, or ALL inputs. You can connect professional equipment with high level (+4dbu) outputs, a) Connect your sound source to the master speaker using one of the following inputs.ī) The Aux (3.5mm) input can be used to connect to personal devices such as cell phones, laptops, and MP3 players.Ĭ) On the back panel, you have two input options. ![]() ![]() (red) wire and the negative (black) wire to the corresponding terminal. Using the supplied wire, connect the Extension Speaker to the Master Speaker by inserting the positive Place speakers on your work surface at arm’s length according to diagram.Ģ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |